steppers and DC motors as cheapo encoders ?
Robot Groups | Search | About
User Password
Register Now! Lost Password?
 comp.robotics.misc    Post an article   get this group's latest topics as an RSS feed add this group's latest topics to your My MSN content add this group's latest topics to your My Yahoo content
Subject Author Date
steppers and DC motors as cheapo encoders ? pogo 04-04-2008
Posted by pogo on April 4, 2008, 6:26 pm
Please log in for more thread options
I'm starting to accumulate quite a few DC motors and steppers from old printers
& scanners, etc.

Does anyone have examples of using them as cheapo encoders ? For example,
sometimes all I need to know is that a wheel is turning
& don't really care about how far or RPM, etc.

Thanks !
JCDeen


Posted by cadcoke4 on April 5, 2008, 12:19 am
Please log in for more thread options
I know that the kinds of uses you are talking about are done.
Specifically, there are some DC motor controllers that stop providing
power for a brief moment so that it can measure the "back EMF".
Essentially using the fact that the DC motor will continue to spin
from its own inertia, and become a generator. I know this is done in
some robotic wheel driver circuits.

Any DC motor can be used like a speedometer. Just measure the voltage
the motor generates while it is being spun in generator mode. (you may
need to filter the voltage to some extent)

I am sure any stepper (or AC) motor can be used in a comparable way,
but instead of a DC voltage, you get an AC waveform. You can use a
frequency counter to measure the speed. It may also be possible to
rectify the AC voltage and then meaure the resulting DC voltage.

Sorry, but I have not done any of the above, only read about them. I
don't have any sources for more info. A search for "robot" and "back
EMF" may be a good start.

Joe Dunfee

Posted by pogo on April 5, 2008, 1:26 am
Please log in for more thread options
>I know that the kinds of uses you are talking about are done.
> Specifically, there are some DC motor controllers that stop providing
> power for a brief moment so that it can measure the "back EMF".
> Essentially using the fact that the DC motor will continue to spin
> from its own inertia, and become a generator. I know this is done in
> some robotic wheel driver circuits.

Yeah my favorite motor controller to date - the Sabertooth 2x10 - works this way
(if I remember correctly).

Thanks !
JCD

Similar ThreadsPosted
hacked steppers, servos, DC motors into something else ? April 4, 2008, 6:34 pm
wire up standard steppers as regular motors ? April 2, 2008, 8:02 pm
windshield wiper motors for robot drive motors ? November 28, 2005, 1:14 am
Encoders with QRD1114 November 6, 2006, 3:03 am
Slowing down quadrature encoders October 21, 2005, 10:47 am
Robot kit that includes wheel encoders? October 4, 2006, 7:04 pm
High resolution, low cost, quadrature encoders August 30, 2005, 9:28 am
difference between "industrial" servo motors and RC servo motors ? February 14, 2006, 8:50 pm
how big do these motors need to be? November 9, 2005, 5:45 pm
CD ROM Motors ? January 25, 2006, 5:28 pm

The site map in XML format XML site map
 other useful resources:
Official Robosapien Website
Lego Mindstorms Website

Contact Us | Privacy Policy